Golden Lighting 8106-9 CDB - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
8. By measuring determine correct number of links
needed for proper hanging height. Use a pair of
pliers to open one link of the Chain (C2) then
remove the excess Chain (C2) and discard it.
9. Use one chain connector(E2) to attach one end of
the chain to the Top loop (D2) and close the chain
connector.
10. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.
11. Slip Canopy loop collar (B2) over the chain, then
do the same with the canopy (F2).
12. When ready to complete the installation Use the
other chain connector and attach the other end of
the chain to the canopy loop (A2) and close the
chain connector.
13. Make sure the weight of the chandelier is
supported by the chain-not the electrical wire.
* You may now install the fixture. Fig 3
3. Unscrew the Deco screws (L,M) from the Frame (K)
and save. 4. Several of the arms are already attached to
the Frame. Gently spread the remaining arms until
evenly spaced.
5. Align the hole in lower side of Frame arm (K) with hole
Frame (K). Secure in place with the Deco screw (M).
6. Repeat with remaining arms both upper and lower,
secure with the Deco screws (L, M).
* NOTE: The Finial can be scratched or broken if the full
weight of the fixture is placed on it. To avoid damage
attach Finial after hanging the fixture.
7. Attach Finial (O) to the base of fixture Frame (K) by
threading the Finial (O) onto the threaded rod (N) until
tight.
Fig 2
PARTS & ASSEMBLY SHEET
Fixture Name: Torbellino 8106-9 CDB
Note: Complete these remaining steps after the
fixture is hung.
14. Place the Glass Shade (Q) over the Threaded
Socket (P),place the Socket washer (R) over the
threaded socket (P) then secure the Glass Shade
(Q) by threading by the Socket Ring (S) until tight.
15. Install the light bulbs in accordance with the
fixture's specifications.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING)
Fig 4
B2
A2
C2
E2
D2
E2