Golden Lighting 7158-9 PW/RBZ - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
PARTS & ASSEMBLY SHEET
Fixture Name: Accurian 7158-9 PW/RBZ
Fig 2
3. Slide the Decorative Rods (R) into the bracket on
Arms (V),and tighten the Screws (U) with Hex Key (O)
(See Detail: A-A")
4. Insert the Decorative Rods (R) into the holes on Top
cap housing (M). Turn housing to one side to allow
easier access, turn back to secure rods in place
5. By measuring determine correct number of links
needed for proper hanging height. Use a pair of pliers
to open one link of the Chain (K) then remove the
excess Chain (K) and discard it.
6. Use one chain connector (L) to attach one end of the
chain to the Top loop (J) and close the chain connector.
7. Feed the fixture wires through the Chain (every three
links) and pull the wires until taut.
8. Slip Canopy loop collar (H) over the chain, then do
the same with the canopy (G).
9. When ready to complete the installation Use the
other chain connector and attach the other end of the
chain to the canopy loop (F) and close the chain
connector.
10. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture. Note: Complete
these remaining steps after the fixture is hung.
11. Slide Glass Shade (P) onto Threaded Socket (Q).
and secure the Glass Shade (P) by using Socket Tool (W)
to thread Socket Ring (N) to Socket tightly.
12. Install the light bulbs in accordance with the
fixture's specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING) )
A-A'
D
C
A-A'
A-A'