beautypg.com

Parts & assembly sheet – Golden Lighting 6262-D5 DNI User Manual

Page 2

background image

ASSEMBLING THE FIXTURE (Fig.2)

4. Feed the fixture wires through the Top loop (J) and pull the

wires until taut.

5. Then screw the Top Loop (J) to the threaded center

column of Frame (M) until tight.

6. By measuring determine correct number of links needed

for proper hanging height. Use a pair of pliers to open one

link of the Chain (C2) then remove the excess Chain (C2)

and discard it.

7. Use one chain connector(E2) to attach one end of the

chain to the Top loop (D2) and close the chain connector.

8. Feed the fixture wires through the Chain (every three links)

and pull the wires until taut.

9. Slip Canopy loop collar (B2) over the chain, then do the

same with the canopy (F2).

10. When ready to complete the installation Use the other

chain connector and attach the other end of the chain to the

canopy loop (A2) and close the chain connector.

11. Make sure the weight of the chandelier will be supported

by the chain-not the electrical wire.

* You may now install the fixture.

Note: Complete these remaining steps after the fixture is

hung.

12. Place the Glass Shades(O) over the Threaded sockets(P),

secure the Glass Shades (O) by threading by the

Socket Rings (N) until tight.

13. Install the light bulbs in accordance with the fixture's

specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING)

PARTS & ASSEMBLY SHEET

Fixture Name: Hampden 6262-D5 DNI

Fig 4

For Customer Service, contact the place of purchase to arrange for replacement parts.

Fig 3

Fig 2

6262-PartsInstallation_101110m.xls