Golden Lighting 3281-9 BI - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
ASSEMBLING THE FIXTURE (Fig. 2)
3. Feed the fixture wires through Top Loop (J) and pull
the wires until taut.
4. Screw Top Loop (J) onto the threaded center
column of the frame until tight.
5. Measure to determine the correct number of chain
links needed for proper hanging height. Use a pair of
pliers to open one link of the chain to remove and
discard any excess chain.
6. Use one chain connector to attach one end of the
chain to the Top Loop (J) and close the chain
connector.
7. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.
8. Slip Canopy Loop Collar (H) over the chain, then do
the same with the Canopy (G).
9. When ready to complete the installation, use the
other chain connector and attach the other end of the
chain to the canopy loop and close the chain
connector.
10. Make sure the weight of the chandelier will be
supported by the chain and not by the electrical wire.
* You may now install the fixture.
Note: Complete the remaining steps after the fixture is
hung.
11. Install the light bulbs in accordance with the
fixture's
specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
Fig 2
Fixture Name: Moreno 3281-9 BI
PARTS & ASSEMBLY SHEET
Fig 4