Golden Lighting 3071-M1L GG - Manual (Page 3)

PARTS & ASSEMBLY SHEET
Fixture Name: Athena 3071-M2L GG
Fig. 2 ASSEMBLING THE FIXTURE (Fig. 2)
2. By measuring, determine the correct number of
links needed for proper hanging height. Use a pair
of pliers to open one link of the Chain (K). Remove
and discard excess Chain (K).
3. Use one chain connector (L) to attach one end of
the chain to Top loop (J) then close the chain
connector.
4. Feed the fixture wires through the chain (every
three links) and pull the wires until taut.
5. Slip Canopy Loop Collar (H) over the chain, then
do the same with the Canopy (G).
6. When ready to complete the installation Use the
other chain connector and attach the other end of
the chain to the Canopy Loop (F) and close the
chain connector.
7. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
8 I
t ll th li ht b lb ( id d) i d
H
F
E
D
A
C
B
L
K
G
L