Golden Lighting 3030-BA1 CH - Manual (Page 2)

For Wall Mount Light Fixture
INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
Fixture Name: Vanora 3030-BA1 CH
For Customer Service, contact the place of purchase to arrange for replacement parts.
Fig. 3
Fig. 1
Fig. 2
HANGING THE FIXTURE(Fig.1)
1.Carefully remove the new fixture from the carton and the
yellow bag that holds all your parts. Check that all
parts are included as shown in the illustration and parts
list.
2. Shut off power at the circuit breaker and remove the old
fixture from wall, including the old mounting strap.
3.Take Threaded Rod (D) from parts bag and thread into
center screw hole on Mounting Strap (A), tighten with
Hex Nut (B) and Spring Washer (C).
4. Attach the Mounting Strap (A) to the Junction Box (I)
using the two Mounting Screws (E). Tighten the screws
securely.
CONNECTING THE WIRES (Fig. 2)
5. Attach the power supply wires to the fixture lead wires
by connecting BLACK to BLACK (or SMOOTH) and
WHITE to WHITE (or RIBBED).
6. Attached the GROUND wire (GREEN or COPPER) from
the Junction Box and the fixture Ground wire to the
green Ground Screw on the Mounting Strap (B) or
connect both wires together using the correct size
of wire connectors
NOTE: Twist the wires together in the same direction you
twist the wire connector onto the wires.
7. Tuck these wire connections neatly into the Junction Box.
FINISHING THE INSTALLATION (Fig. 3)
1. Place fixture Back Plate (P), over
Threaded Rod (D), so that it protrudes through the hole in
Back Plate (P).
2. Thread Deco Nut (I) onto Threaded Rod (D)
and continue turning until Back Plate (P) is snug
against the wall .
3. Slide Outer Glass Shade (J) on over Socket (H). (Note: The
gap at the bottom of the glass should be turned toward inside.)
Then, slide Inner Glass Shade (K) and Spacer (L) over Socket
(H). Secure Outer Glass Shade (J), Inner Glass Shade (K), and
Spacer (L) in place using Socket Tool (O) to thread Socket Ring
(M) onto the Socket (H) until tight.
4. Install the Light Bulb (N) in accordance with the
fixture's specifications.
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX
AND TEST THE FIXTURE.
B A D C F IX TU RE W IRE S H O US E W IRE S F i g . 2
JUNCTION BOX
GND
A I C B
G F D E
BARE COPPER
(or Green)
GREEN
(Ground)
FIXTURE WIRES
SMOOTH ( or BLACK)
RIBBED ( or WHITE)
BLACK
(Hot)
WHITE
(Netural)
HOUSE WIRES
220V 25W
G9
H
I
J
K
L
M
N
P
O