Golden Lighting 2073-M1L WG - Manual (Page 2)

F For Customer Service, contact the place of purchase to arrange for replacement parts.
2073-M1L INSTALLATION INSTRUCTIONS PART 1
INSTALLATION INSTRUCTIONS
Fixture Name: SMYTH 2073-M1L GMT
Mini Pendant Light Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
HANGING THE FIXTURE (Fig.1)
1. Carefully remove the new fixture from the carton
as well as the yellow parts bag. Check that all
parts are included as shown in the illustrations and
the Parts and Assembly Sheet.
2. Shut off power at the circuit breaker and
completely remove the old fixture from ceiling,
including the old mounting strap.
3. The Mounting Strap (B) contains several pairs of
threaded holes, find the pair of holes that matches
the holes spacing in your fixture canopy (E).
Thread Fixture Mounting Screws (A) half way into
the Fixture Mounting Strap (B).
4. Place the Mounting Strap (B) over the Junction
Box so that Mounting Screws (A) are vertical or
horizontal, as required by the fixture type.
5. Attach the Fixture Mounting Strap (B) to the
Junction Box using Mounting Screws (C). Tighten
the screws securely with a screw driver.
CONNECTING THE WIRES（Fig.2）
6. Attach the power supply wires to the fixture lead
wires by connecting BLACK to BLACK (or SMOOTH)
and WHITE to WHITE (or RIBBED).
7. Ground Wire Connection: Connect the fixture
ground wire to the supply ground wire (this usually
has green insulation) with wire connector. If there is
no supply ground wire at ceiling junction box then
attach the fixture ground wire securely onto green
grounding screw located at mounting bar.
NOTE: Twist the wires together in the same direction
you twisted the wire connector onto the wires.
8. Tuck these wire connections neatly into the
Junction Box.
FINISHING THE INSTALLATION（Fig.3）
9. Place Canopy (E) over Mounting Screws (A) and
secure Canopy (E) against the wall by threading
Deco Nuts (F) over Mounting Screws (A) until tight
as shown on Fig.3.
10. Install the light bulb in accordance with the
fixture’s specifications.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE FIXTURE.
Fig. 1
Fig.2
Fig.3
FIXTURE WIRES
SMOOTH
(or Black)
RIBBED
(or White)
BARE COPPER
(or Green)
HOUSE WIRES
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
JUNCTION
BOX
(CEILING)
A
B
C
D
E
F
JUNCTION
BOX
(CEILING)
A
E
F