Golden Lighting 2073-1W GMT - Manual (Page 2)

F For Customer Service, contact the place of purchase to arrange for replacement parts.
2073-1W GMT INSTALLATION INSTRUCTIONS PART 1
INSTALLATION INSTRUCTIONS
Fixture Name: SMYTH 2073-1W GMT
For Wall Mount Light Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
HANGING THE FIXTURE (Fig.1)
1. Carefully remove the new fixture from the carton
and the yellow parts bag. Check that all parts are
included as shown in the illustrations and the Parts
and Assembly Sheet.
2. Shut off power at the circuit breaker and remove
the old fixture from wall, including the old
mounting strap.
3. Mounting Strap (A) contains several pairs of
threaded holes. Find the pair of holes that matches
the spacing of the holes in your Fixture Back Plate
(D) and thread the Fixture Mounting Screws (C)
half way into the Fixture Mounting Strap (A).
4. Place the Mounting Strap (A) over the Junction
Box so the Fixture Mounting Screws (C) are vertical
or horizontal, as required by the fixture type.
5. Attach the Fixture Mounting Strap (A) to the
Junction Box using Mounting Screws (B). Tighten
the screws securely with a screw driver.
CONNECTING THE WIRES(Fig.2)
6. Attach the power supply wires to the fixture lead
wires by connecting BLACK to BLACK (or SMOOTH)
and WHITE to WHITE (or RIBBED).
7. Ground Wire Connection: Connect the fixture
ground wire to the supply ground wire (this usually
has green insulation) with wire connector. If there is
no supply ground wire at ceiling junction box then
attach the fixture ground wire securely onto green
grounding screw located at mounting bar.
NOTE: Twist the wires together in the same direction
you twisted the wire connector onto the wires.
8. Tuck these wire connections neatly into the
Junction Box.
FINISHING THE INSTALLATION (Fig.3)
9. Place the fixture Back Plate (D) over the two
Mounting Screws (C) and secure the Back Plate
(D) against the wall by threading Deco Nuts (E)
over the Mounting Screws (C) until tight.
10. Install the glass as per the Parts and Assembly
Sheet.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE FIXTURE.
Fig. 1
Fig.2
Fig.3
JUNCTION BOX
D
B
A
C
FIXTURE WIRES
SMOOTH
(Or Black)
RIBBED
(Or White)
BARE COPPER
(Or Green)
HOUSE WIRES
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
JUNCTION BOX
D
E
C