Golden Lighting 1821-FM BI User Manual
Parts & assembly sheet, Parts list
Mounting
Strap
Mounting screw
Stem With Hex
Nut
1ea
L4"*H1.5mm
4ea 8/32-IP*H1"
1ea @3/8 x 110mm
Hex nut
Wire connnector
Deco Nut
3 ea P4 Orange
Bottom cap
Finial
Flat Washer/Rubber
Washer
Part Needed
Quantity
Part Needed
Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
For Customer Service, contact the place of purchase to arrange for replacement parts.
NOTE: I
NSTALL THE GLASS ASSEMBLY
AFTER THE FIXTURE IS HUNG.
1. Thread the Stem With Hex Nut (G) into the Coupling
of the Ceiling Pan (F) until tight.
2. Install the lighting bulbs in accordance with the
fixture's specification.
3. Place the Flat Washer (H), Rubber Washer (I),
Glass Shade (J), Rubber Washer (I), Scrolled cage (K)
over the Stem (G) and thread Hex Nut (L) on until
tight.
4. Slide Bottom Cap (M) over Stem With Hex Nut (G)
and thread the Finial (N) until tight.
(DO NOT EXCEED MAXIMUM WATTAGE RATING!)
Fig 1
1821-FM BI
Read and review installation instruction sheet
before assembling the fixture.
PARTS & ASSEMBLY SHEET
This fixture assembled PO:__________ Date: ________
Fixture Name: Madera 1821-FM BI
1ea / 2ea
3/8-IP*H3mm / 8/32-IP*H3mm
Notice:
Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or
damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.
PARTS LIST
Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
2ea 12mmx 11mm
F
IXTURE
A
SSEMBLY
I
NSTRUCTIONS
1ea/2ea @1-1/2" x 2mm
1ea Φ75*H14mm
1ea 3/8-IP*H14mm
F
G
H
I
J
K
I
L
N
M