Golden Lighting 1425-BA4 WG - Manual

Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
F IXTURE A SSEMBLY I NSTRUCTIONS
Read and review installation instruction sheet, but
do not install before assembling the fixture.
1425-BA4 WG
ASSEMBLING THE FIXTURE (Fig.1)
1. Crystal Chains (T) are individually wrapped and
must be hung piece by piece. Remove Crystal
Chain (T) from the packaging and examine the
chain for Connection Pin (U). Drape Crystal Chain
(T) over Arm (S) so that Connection Pin (U) sits on
top of Arm (S). This will ensure proper draping
length.
2. Install outer, Clear Glass (S) and inner, Opal
Glass (R) by sliding both pieces of glass over
Socket (T). Place Gasket (Q) inside Opal Glass (R)
and over Socket (T). Secure glass in place by
tightening Socket Ring (P) over Socket (T), using
Socket Tool (X).
Note: To avoid broken glass, do not over tighten
Socket Ring (P). Fig 1
NOTE: I NSTALL THE GLASS ASSEMBLY
AFTER THE FIXTURE IS HUNG.
PARTS & ASSEMBLY SHEET
Fixture Name: Sancerre 1054-BA4 WG
This fixture assembled PO:__________ Date: ________
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are
missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement
parts.
PARTS LIST Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
Mounting Strap Mounting Screws Deco Nut
1ea ∅4"*H2mm 2ea 8#32-IP*1" 2ea 8#32-IP*H9mm
Wire connectors Mounting Screws Hex Nut
3ea P3 Orange 2ea 8#32-IP*1" 2ea 8#32-IP*H3mm
Socket Tool
1ea 1-1/8"*3-5/8"