Golden Lighting 1425-9 WG - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
3. Feed the fixture wires through Top loop (J) and pull
the wires until taut. Then screw Top Loop（J） to the
threaded center column of Frame (M) until tight. .
4. By measuring, determine correct number of links
needed for proper hanging height. To remove any
excess chain, use a pair of pliers to open one link of
Chain (K) and discard the excess chain.
5. Use one Chain Connector (L) to attach one end of the
chain to Top Loop (J). Then close the chain connector.
6. Feed the fixture wires through the chain (every three
links) and pull the wires until taut.
7. Slip Canopy Loop Collar (H) over the chain, then do
the same with the Canopy (G).
8. When ready to complete the installation, use the
other chain connector and attach the other end of the
chain to the Canopy Loop (H). Then close the chain
connector.
9. Feed the fixture wires through Canopy Loop (F) and
Nipple (C) and pull until taut.
* You may now install the fixture.
Fig 2
ASSEMBLING THE FIXTURE (Fig.3)
1. Crystal Chains (S) are individually wrapped and must
be hung piece by piece. Remove Crystal Chain (S) from
the packaging and examine the chain for Connection
Pin (T). Drape Crystal Chain (S) over Arm (R) so that
Connection Pin (T) sits on top of Arm (R). This will
ensure proper draping length.
2. Attach Crystal Bobeche (P) by sliding it over the
socket. Then, slide Candle Sleeve (O) into the hole and
straighten.
Note: Please do not attempt to slide Crystal Bobeche
(P) over the chrome Candle Sleeve (O) as it will scratch
and damage the finish of the candle sleeve.
Fig 3
PARTS & ASSEMBLY SHEET
Fixture Name: Sancerre 1425-9 WG