Golden Lighting 1425-5 WG - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
3. Feed the fixture wires through Top loop (J) and pull the wires
until taut. Then screw Top Loop（J） to the threaded center
column of Frame (M) until tight. .
4. By measuring, determine correct number of links needed for
proper hanging height. To remove any excess chain, use a pair
of pliers to open one link of Chain (K) and discard the excess
chain.
5. Use one Chain Connector (L) to attach one end of the chain to
Top Loop (J). Then close the chain connector.
6. Feed the fixture wires through the chain (every three links)
and pull the wires until taut.
7. Slip Canopy Loop Collar (H) over the chain, then do the same
with the Canopy (G).
8. When ready to complete the installation, use the other chain
connector and attach the other end of the chain to the Canopy
Loop (H). Then close the chain connector.
9. Feed the fixture wires through Canopy Loop (F) and Nipple
(C) and pull until taut.
* You may now install the fixture.
Fig 2
ASSEMBLING THE FIXTURE (Fig.3)
1. Crystal Chains (S) are individually wrapped and must be hung
piece by piece. Remove Crystal Chain (S) from the packaging
and examine the chain for Connection Pin (T). Drape Crystal
Chain (S) over Arm (R) so that Connection Pin (T) sits on top of
Arm (R). This will ensure proper draping length.
2. Attach Crystal Bobeche (P) by sliding it over the socket. Then,
slide Candle Sleeve (O) into the hole and straighten.
Note: Please do not attempt to slide Crystal Bobeche (P) over
the chrome Candle Sleeve (O) as it will scratch and damage the
finish of the candle sleeve.
Fig 3
PARTS & ASSEMBLY SHEET
Fixture Name: Sancerre 1425-5 WG