Golden Lighting 1425-3P WG - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
3. Feed the fixture wires through Top loop (J) and pull the
wires until taut. Then screw Top Loop（J） to the threaded
center column of Frame (M) until tight. .
4. By measuring, determine correct number of links needed
for proper hanging height. To remove any excess chain, use
a pair of pliers to open one link of Chain (K) and discard the
excess chain.
5. Use one Chain Connector (L) to attach one end of the
chain to Top Loop (J). Then close the chain connector.
6. Feed the fixture wires through the chain (every three links)
and pull the wires until taut.
7. Slip Canopy Loop Collar (H) over the chain, then do the
same with the Canopy (G).
8. When ready to complete the installation, use the other
chain connector and attach the other end of the chain to the
Canopy Loop (H). Then close the chain connector.
9. Feed the fixture wires through Canopy Loop (F) and
Nipple (C) and pull until taut.
* You may now install the fixture.
Fig 2
1. Attach Crystal Bobeche (U) by sliding it over the
socket. Then, slide Candle Sleeve (O) into the hole
and straighten.
Note: Please do not attempt to slide Crystal Bobeche
(P) over the chrome Candle Sleeve (O) as it will
scratch and damage the finish of the candle sleeve.
Fig 3
PARTS & ASSEMBLY SHEET
Fixture Name: Sancerre 1425-3P WG