Golden Lighting 1212-9 AB - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
PARTS & ASSEMBLY SHEET
Fixture Name:Corsica 1212-9 AB
Fig. 2
7. Slip Canopy loop collar (H) over the chain, then do the
same with the canopy (G).
8. When ready to complete the installation Use the other
chain connector and attach the other end of the chain to
the canopy loop (F) and close the chain connector.
9. Make sure the weight of the chandelier will be supported
by the chain-not the electrical wire.
* You may now install the fixture.
ASSEMBLING THE FIXTURE (Fig. 2)
5. By measuring determine correct number of links
needed for proper hanging height. Use a pair of
pliers to open one link of the Chain (K) then remove
the excess Chain (K) and discard it.
6. Use one chain connector (L) to attach one end of
the chain to the Top loop (J) and close the chain
connector.
7. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.
8. Slip Canopy loop collar (H) over the chain, then
do the same with the canopy (G).
9. When ready to complete the installation Use the
other chain connector and attach the other end of
the chain to the canopy loop (F) and close the
chain connector.
10. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
11. Install the light bulbs (not provided) in
accordance with the fixture's specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
12. Carefully press the clips inside of the shade
(Q) onto the bulb.
C
D
J
M
N
O
P
Q
R
Bulb
(Not Prov