Golden Lighting 1157-M1L CH - Manual (Page 2)

PARTS & ASSEMBLY SHEET
Fixture Name: Payton 1157-M1L CH/AB
Fig. 2
For Customer Service, contact the place of purchase to arrange for replacement parts.
7. Slip Canopy loop collar (H) over the chain, then do the
same with the canopy (G).
8. When ready to complete the installation Use the other
chain connector and attach the other end of the chain to
the canopy loop (F) and close the chain connector.
9. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
ASSEMBLING THE FIXTURE (Fig. 2)
2. Measure to determine the correct number of
links needed for the proper hanging height. Use
a pair of pliers to open one link of the Chain (K)
then remove and discard the excess chain.
3. Use one Chain Connector (L) to attach one
end of the chain to Top Loop (J) and close the
chain connector.
4. Feed the fixture wires through the chain
(every three links) and pull the wires until taut.
5. Slip Canopy Loop Collar (H) over the chain.
Then do the same with Canopy (G).
6. To complete the installation, use the other
chain connector and attach the other end of
the chain to Canopy Loop (F) and close the
chain connector.
7. Make sure the weight of the chandelier will
be supported by the chain, not the electrical
wire.
* You may now install the fixture.
Note: Complete these remaining steps after
the fixture is hung.
8. Install the light bulb (not provided) in
accordance with the fixture's specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING )