Golden Lighting 1157-6P AB - Manual (Page 3)

INSTALLATION INSTRUCTIONS
7. Unscrew Canopy Loop Collar (H ) from the canopy loop.
Take the canopy and pass over the canopy loop.
Approximately one half of the canopy loop exterior threads
should be exposed. Adjust until desired height is reached. *The
canopy loop collar should fit snugly on the canopy loop after
the canopy is installed. Remove canopy and canopy lock
collar.
8. Assemble the fixture and have an assistant or a secure
support to hold the weight of the fixture while you complete
the wiring connections.
9.Thread the fixture wires and ground wire of the assembled
fixture through the canopy loop and nipple and into the outlet
box.
CONNECTING THE WIRES (Fig 2)
10. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to WHITE (
or RIBBED) .
11. Ground wire connection: Connect the fixture ground wire
to house ground wire, which usually has green or copper
insulation, with the correct size of wire connector. If there is no
house ground wire at ceiling junction box then attach fixture
ground wire securely onto green grounding screw located on
the mounting bar.
NOTE: Twist the wires together in the same direction that you
twisted the wire connector onto the wires.
12. Tuck the wire connections into the Junction Box.
Fig. 2
For Customer Service, contact the place of purchase to arrange for replacement parts.
Fixture Name: Payton 1157-6/4/3P CH/AB
For Chandelier Light Fixture
WARNING! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
13. Raise Canopy (G) to the ceiling and secure in place by
tightening the Canopy Loop Collar (H) into the Canopy Loop
(F)
14. Install the light bulbs and glass shade as per the fixture
assembly sheet.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE
FIXTURE.
HANGING THE FIXTURE (Fig.1)
1. Carefully remove the new fixture from the carton and the
yellow bag that holds all parts. Check that all parts are
included as shown in the illustration and Parts List.
2. Shut off the power at the circuit breaker and remove the old
fixture from the ceiling, including the old mounting strap.
3. Thread Nipple (C) into Canopy Loop (F) until snug.
4. Thread the other end of Nipple (C) with the canopy loop
attached into Mounting Strap (D).
5. Place Lock Washer (B) over end of Nipple (C) which should
protrude through Mounting Strap (D) and thread Hex Nuts (A)
onto Nipple until tight.
6. Take this mounting strap assembly and mount to ceiling
junction box with junction box Screws (E). Tighten the screws
securely with a screw driver.
Fig. 1