Golden Lighting 1051-BA3 SBZ - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
5. Attach the Mounting Plate (B) to Junction Box by using the
two Junction Box Screws(E). If Anchors (A) were attached to
the wall, secure the Mounting Plate (B) with two Anchors
Screws (D) to corresponding holes.
CONNECTING THE WIRES (Fig 2)
6. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to
WHITE (or RIBBED).
7. Attach the GROUND wire(GREEN or COPPER) from the
Junction Box and the fixture Ground wire to the green Ground
Screw on the Mounting Plate (B) or connect both wires
together using the correct size of wire connectors.
NOTE: Twist the wires together in the same direction you twist
the wire connector onto the wires.
8. Tuck these wire connections neatly into the Junction Box.
Fig. 2
FINISHING THE INSTALLATION (Fig.3)
9. After tucking these wire connections neatly into the
Junction Box and place the fixture Front Plate (G) over the two
Mounting Screws (C) and secure against the Mounting Plate
by threading two Deco Nuts (I) over the two Mounting Screws
(C) until snug against the wall.
10. Install the light bulbs and glass shade as per the fixture
assembly sheet.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE FIXTURE.
Fig. 3
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE (Fig.1)
1. Carefully remove the new fixture from the carton and the
yellow bag that holes all your parts. Check that all parts are
included as shown in the illustration and parts list.
2. Shut off power at the circuit breaker and remove the old
fixture from wall, including the old mounting strap.
3. Hold Mounting Plate (B) up against the wall aligning the two
holes in the Junction Box with appropriate slots in the
Mounting Plate (B). Then while the Mounting Plate (B) is
leveled horizontally, use a pen or pencil to make a mark on
the wall at holes located near each end of mounting Plate (B).
Set aside the Mounting Plate (B) and insert Wall Anchors (A)
into the two marks made on the wall.
4. Thread the supply wires and ground wire from Junction Box
through center holes in Mounting Plate (B).
Fig. 1
INSTALLATION INSTRUCTIONS
Fixture Name: Hidalgo 1051-BA3 SBZ
For Wall Mount Light Fixture