Parts & assembly sheet – Golden Lighting 1051-3P SBZ User Manual
Page 2

For Customer Service, contact the place of purchase to arrange for replacement parts.
5. By measuring determine correct number of links
needed for proper hanging height. Use a pair of pliers
to open one link of the Chain (C2) then remove the
excess Chain (C2) and discard it.
6. Use one chain connector (E2) to attach one end of
the chain to the Top loop (D2) and close the chain
connector.
7. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.
8. Slip Canopy loop collar (B2) over the chain, then
do the same with the canopy (F2).
9. When ready to complete the installation Use the
other chain connector and attach the other end of the
chain to the canopy loop (A2) and close the chain
connector.
10. Make sure the weight of the chandelier is
supported by the chain-not the electrical wire.
* You may now install the fixture.
Fig 3
PARTS & ASSEMBLY SHEET
Fixture Name: Hidalgo 1051-3P SBZ
NOTE: Finish installing the glass after the fixture is
hung.
11. Thread the Nipple (E) into the Socket assembly
(D), lock into position by the tightening hex nut.
12. Install the light bulbs in accordance with the
fixture’s specifications.
13. Slide the Glass shade (F), Rubber washer (K),
Metal washer (L) over the Nipple (E) secure them by
the Hex Nut (M).
14. Slide the Bottom Cap (N) over the Nipple (E),
screw the Finial (O) onto the Nipple (E) until tight.
(DO NOT EXCEED THE MAXIMUM WATTAGE
RATING)
.
Fig 4
4. Slide Center Ring (H) up to the Arms (C) and
make the screw(G) through the hole of the Steel
clip(J) ,secure with Ball nut(I). (see Fig2)
Fig 2
B2
A2
C2
E2
D2
E2