Golden Lighting 1030-363 CH - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
ASSEMBLING THE FIXTURE (Fig.2)
4. Feed the fixture wires through the Top loop (D2) and pull
the wires until taut. Then screw the Top Loop
（D2） to the
coupling on the top of fixture (D) until tight.
5. By measuring determine correct number of links needed
for proper hanging height. Use a pair of pliers to open one
link of the Chain (C2) then remove the excess Chain (C2)
and discard it.
6. Use one chain connector (E2) to attach one end of the
chain to the Top loop (D2) and close the chain connector.
7. Feed the fixture wires through the Chain (every three
links) and pull the wires until taut.
8. Slip Canopy loop collar (B2) over the chain, then do the
same with the canopy (F2).
9. When ready to complete the installation Use the other
chain connector and attach the other end of the chain to the
canopy loop (A2) and close the chain connector.
10. Feed the fixture wires through canopy loop (F) and
nipple(C) and pull until taut.
* You may now install the fixture.
Fig 2
PARTS & ASSEMBLY SHEET
Fixture Name: Cerchi 1030-363 CH
Note: Complete these remaining steps after the fixture is
hung.
11. Place the Glass Shades(P) over the Threaded Sockets
(Q), secure with Socket washer (O) and by threading the
Socket Rings(N) until tight.
12. Install the light bulbs in accordance with the fixture's
specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
Fig 3