Philips VR 337 - Manual (Page 33)

/i\ /i\ /}\ /P\
DATUM FROG. START ERDE
^ ^ ^
TIMER
Programming on the video recorder
You can enter and store data for six recordings in your
video recorder.
The video recorder display will indicate all data
simultaneously. Use the four C3iH] buttons on the
remote control to enter the data.
The data will be stored in the next free TIMER block in
the video recorder.
Make sure you have not loaded a cassette with erase
protection.
O
Press the I .T.iMER_.a__ I button on the remote control.
DU njD /i'
n.nn 'in.nn
''PS
L. 1 UD f I'UU lU’UU
_______ II________ Jl____ __________ IL II 1
A free TIMER block will appear in the video recorder
display. You will see the current (= todayl) data for the
date, programme number, start time and stop time.
Change the data in any sequence you choose:
• Set the date of the recording with the I
datum
+/ - I
button.
• Set the programme number with the
button.
PROG. +/-
Set the start time with the I
start
+/- I button.
Set the stop time with the I..END.E—+.Lr-l button.
Switch VPS on or off with the LS ps J button.
O Have you set all the data correctly? Now press the
I OK Ihiittnn on the remote control.
T I iuirn m~ riTii I
I I I n_/ \ I \l_ I I ±1^1
As confirmation, TIMER READY' appears in the video
recorder display.
Programming is now complete.
The data has been stored in a TIMER block.
One of the squares on the right-hand side of the display
lights up for each TIMER block that is occupied.
30 (5)