Philips VR 337 - Manual (Page 20)

4. STORING TV CHANNELS
In order to be able to record TV programmes you must
first store all the TV channels (e.g.: 'BBC1') in your
video recorder.
You can store up to 42 different TV channels.
Your video recorder has its own receiver. This means
that it can be used independently of your TV set.
For the subsequent use of 'Programming with
ShowView' you also have to allocate a so-called 'aerial
code' to each TV channel . You will find a code table in
your TV guide.
Automatic channel search
The video recorder will search for all TV channels at the
same time and store them in its memory in the order in
which it finds them.
O
Switch on the TV set.
Many modern TV sets automatically switch to the
video programme number at step ©. However, this
will only function if your video recorder is connected
to the TV set with an AV-Euro cable.
Otherwise, select the video programme number on
your TV set.
0 With the video recorder switched off, press the
I AUTOSTORE I button on your vldeo recorder. The
automatic channel search function starts.
'AUTOSTORE' will appear in the display.
~ / i I T n r ~ T i ~ i n r
lU ‘ U_i ‘ Ui' L
nn ....
U U ■
O Wait until the video recorder has found all of the TV
channels. This can take several minutes.
O Identify the TV channel to which you are tuned.
Use the digit buttons I.Q-.Qjto allocate the correct
'aerial code' to it. You will find a code table in your
TV guide .
If necessary, you can clear with button LUTSCHEM^ .
If you do not want, or cannot select, certain aerial
codes at this time, you can also select them later
with the function 'Allocating channel numbers'.
nn w
i~u I
''¡on c
lUU' _(
n /
CDl 17