Philips CD951 - Manual (Page 10)

SYSTEM ASPECTS
ENHANCED SYSTEM INTELLIGENCE (ESI) STAND BY
m 3
;
5‘ i
3"
If the player is connected via the ESI BUS sockets to the
ESI BUS sockets of a HiFi system (e.g. the PHILIPS 900
series), the player can be operated via the remote control of
the system. In addition, the functions mentioned below are
then accessible (if available in the system);
N O T E !
When connecting the ESI BUS to the ESI BUS of the HiFi
system the CD player should be
sw itch ed o ff.
• With the STAND BY button on the remote control of the
system you can set the player to STAND BY mode.
The player will go to STAND BY mode automatically if the
whole system is set to STAND BY mode.
- If the CD compartment was open, it will now close.
- Any programme present will be erased.
• Press any of the following buttons to cancel the STAND BY
mode:
PLAY/REPLAY, STOP/CP, SCAN, SHUFFLE, 0-9,
OPEN/CLOSE, !◄ TRACKS, FTS or PROG(ramme).
CD DUBBING (synchronized recording) TIMER
• Set the player to the STOP mode.
• Select the TD mode (if available) on the cassette deck.
• Press CD SYNC. (CD DUBBING) on the cassette deck.
- Playback starts but nothing is being recorded yet; you can
nov\T adjust the recording level.
• Press PLAY on the deck.
- Recording starts and after 6 seconds play starts again at the
beginning of the CD or the programme.
- After each track an extra pause of 4 seconds (AUTO SPACE)
will be inserted.
- AUTOSPACE lights up.
- At the end of side A of the tape, synchronized recording will
stop, except when the ID mode has been selected on the
cassette deck; the CD player will then go into PAUSE mode.
The tape travel direction for side B will be selected
automatically and the current track will be recorded again on
side B of the tape.
- After the last track synchronized recording will stop.
• Using the tuners TIMER function you can have playback
(of a CD or a programme) started at a particular time; for this
refer to the operating instructions of the tuner (e.g FT930).
- TIMER CANCELLED will light up if there is no CD in the
CD compartment at the moment playback is supposed to
start or if you press any button during playback in the TIMER
mode.
N O T E !
As soon as you start recording, the other player functions
(except TIME and REVIEW) will temporarily be switched
off to prevent the recording being interfered with;
CD-DUBBING flCTIi-'E lights up if you press one of the
other buttons during play/recording.
You can stop playbacIVrecording by pressing STOP/CP or
OPEN/CLOSE; CD-DUBBING CANCELLED then lights
up.
During dubbing the volume set with - VOLUME + will be
cancelled and returned to the sound level set on the
amplifier.
The-VOLUME + keys may not be used during dubbing
as they affect the strength of the signal from the player.
After dubbing the sound level will be returned to the level
set with - VOLUME +.
The CD DUBBING function will be cancelled if the CD
player (or the system) is set to STAND BY mode
AUTOMATIC SOURCE SELECTION
If the AUTO SELECT button on the amplifier is pressed, the
CD player will automatically be activated as soon as you press
PLAY/REPLAY, 0-9, SCAN or SHUFFLE.
AUTOMATIC STOP
If the AUTO SELECT button on the amplifier is pressed, the
CD player will automatically go into the PAUSE mode as soon
as another source in the system is selected (except when CD
DUBBING is active).
10