Flyzone FLZA3300 - Manual (Page 11)

11
FULL
THROTTLE
RUDDER
MOVES
RIGHT
ELEVATOR
MOVES DOWN
RIGHT AILERON
MOVES UP
LEFT AILERON
MOVES DOWN
4-CHANNEL RADIO SETUP (STANDARD MODE 2)
❏
3. View the model from behind and move the rudder
control (left stick) on the transmitter to the left. The rudder
should move to the left. If not, move the rudder reversing
switch on the transmitter and then test the operation of the
rudder again.
❏
4. Moving the elevator control down (right stick) should
cause the elevator to move up. Flip the elevator reversing
switch on the transmitter if necessary.
❏
5. Moving the aileron control to the right (right stick)
should cause the left aileron to move down and the right
aileron to move up. Flip the aileron reversing switch on the
transmitter if necessary.
❏
6. If you have not yet done so, set all of your trim levers
to the neutral position. Confi rm that all of the control surfaces
are still in the neutral position. Confi rm that the servo arms
are still perpendicular to the pushrods as shown. If necessary,
remove the servo arm screws, adjust the positions of the servo
arms on the servos and replace the screws. Make any fi nal
adjustments to the control surfaces by moving the pushrods
forward or aft in the adjustable clevises (be sure to re-tighten
the clevis screws if you make adjustments). The procedure
for centering the ailerons is done in the same manner.
❏
7. When checking the propeller operation, BE SURE
TO KEEP YOUR HANDS, CLOTHING, ETC. BEHIND
THE SPINNING ARC OF THE PROPELLER!
Operate the
propeller outside, clear of any obstacles, and be sure that you
have a fi rm grasp on the airplane before applying throttle.