Cabletron Systems BRIM-WT1 - Manual (Page 13)

BRIM-WT1 USER’S GUIDE Page 5
CHAPTER 2
INSTALLATION
This chapter describes how to install the BRIM-WT1 to the
MicroMMAC. To install the BRIM-WT1, you need to remove
MicroMMAC’s chassis cover. Refer to the MicroMMAC User’s Guide for
instructions to remove the chassis cover. You also need a Phillips-head
screwdriver to install the BRIM-WT1.
2.1 UNPACKING THE BRIM-WT1
Unpack the BRIM-WT1 as follows:
1. Remove the shipping material covering the BRIM-WT1 in the
shipping box.
2. Carefully remove the BRIM-WT1 from the shipping box.
3. Remove the BRIM-WT1 from the protective plastic bag and set it
aside to prevent damage.
4. Visually inspect the BRIM-WT1. If there are any signs of damage,
contact Cabletron Systems Technical Support immediately.