Flintec LDU 69.1 - Manual (Page 25)

LDU 69.1 Technisches Handbuch, Rev. 12 January 2011 Page 25 of 28
8.10. Save Calibration and Setup Data Commands – CS, WP
The calibration and setup parameters can be divided in 2 groups:

Calibration : CMn, CI, MR, DS, DP, CZ, CG, ZT, ZR, FD, LC and LNn, saved by command CS

Setup : FL, FM, NR, NT, BR, AD, DX and other, saved by command WP
Note: Calibration data can only be saved if the TAC code is known and precedes the CS command. See the
CE and CS commands in chapter 8.2.
The setup data are stored non-volatile in the EEPROM using the WP command.
8.10.1. WP Einstell-Parameter sichern
With this command the settings of the “Filter” (FL, FM) ,the “No-motion” (NR, NT) and the communication (AD,
BR, DX) will saved in the EEPROM.
Master (PC / SPS) sends Slave (LDU XX.X) responds Meaning
WP  OK Save setup data
WP
 ERR Error