Estes 4601 - Mad Cat - Manual (Page 2)

2
Helicopter and Controller Parts
Helicopter
Controller
1. Remove the screw above the battery cover
using a Phillips-head screwdriver.
2. Install 4 “AA” size batteries following the
polarity shown inside.
3. Replace and tighten the screw clockwise.
4. The controller’s LED fl ashes when the
batteries are low.
Controller Battery Installation
Infrared signal emitter
Band selector
Throttle stick Direction stick
Left Trim
Button
Right Trim
Button
Power switch
Throttle Down
Position
Counter-rotating
rotor blades
Charging Jack
Tail Rotor
Landing Gear
+
+
+
+
–
–
–
–