beautypg.com

Estes 1887 – Super Shot Mini User Manual

Super shot, Mini flying model rocket instructions, Prepare engine for flight

background image

D. Wrap shock cord loosely around

streamer. Insert streamer into rocket.
Streamer should slide easily into body
tube. If fit is too tight, unfold and repack.

MINI FLYING MODEL

ROCKET INSTRUCTIONS

KEEP FOR FUTURE REFERENCE

3. PREPARE ENGINE FOR FLIGHT

ESTES INDUSTRIES

1295 H Street

Penrose CO 81240

PRINTED IN CHINA

A. Separate igniter and

igniter plug.

B. Twist off retainer ring

at rear of rocket.

C. Slide engine into rocket

body as shown.

D. Twist retainer ring into

locked position to hold
engine in place.

F. Insert igniter

plug.

G. Firmly push igniter

plug all the way in.

2. PREPARE STREAMER FOR FLIGHT

A. Loosely crumple and

insert 1/4 of a square
of recovery wadding
into rocket body

B. Measure 1 (2.5 cm) from the nose cone and tie

streamer to shock cord with a double knot.

1

(2.5 cm)

E. Hold rocket upside down

and drop in igniter. Igniter
must touch propellant.

A. Pull the nose cone out of

the rocket body.

1. ROCKET STREAMER ATTACHMENT

H. Bend igniter wires

back as shown.

Typical rocket
(your design
may vary)

SHOCK CORD

IMPORTANT:
Wadding must be in place and slide
freely for rocket to work properly!

¤

NOSE CONE

B. FOLD

STREAMER

C. ROLL

www.estesrockets.com

SUPER SHOT

#1887

ASSEMBLY TIP:

Read all instructions before beginning work

on your model. Make sure you have all parts and supplies.

Use these instructions for each of your Super Shot“ rockets.

WARNING : FLAMMABLE

To avoid serious injury, read instructions & NAR

Safety Code included with engines.

PREPARE YOUR ENGINE ONLY WHEN

YOU ARE OUTSIDE AT THE LAUNCH SITE

PREPARING TO LAUNCH!

If you do not use your prepared engine, remove

the igniter before storing

your engine.

TM

NOTE: Only Estes wadding (#302274) recommended.