Clarion VB475 - Manual (Page 30)

30 VB475
English
7. Use the screw (B15x16) to attach the other side of the assembly bar to the vehicle
body.
8. Attach the trim ring to the front of the player.
Cable connections
• Refer to the owner’s manual for the power amplifi er and for other units before you
make connections.
• Secure wiring with cable clamps or adhesive tape. To protect the wiring, wrap
adhesive tape around the wires where they lie against metal vehicle parts.
• Route and secure all wiring so that it cannot touch any moving parts, such as the
gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such
as near the heater outlet. If the insulation of the wiring melts or gets torn, it could
short circuit to the vehicle body.
• Don’t pass the yellow lead through a hole with a grommet into the engine
compartment to connect to the battery. This will damage the lead insulation and
cause a very dangerous short.
• Do not shorten any leads. If you do, the protection circuit may fail to work when it
should.
• Never feed power to other equipment by cutting the insulation of the player’s power
supply lead to tap into the lead. The current capacity of the lead will be exceeded
causing overheating.
• When replacing the fuse, use only a fuse with the same rating (10A).
VB475OwnersManual.indd 30 VB475OwnersManual.indd 30 1/27/2007 9:34:39 PM 1/27/2007 9:34:39 PM