Emerson Radio ES8 - Manual (Page 8)

7
LISTENING TO RADIO
PRESET EQUALIZER
• This unit is equipped with a preset equalizer which has been added to enhance
your listening pleasure by altering the frequency response of the music.
• Press the Preset EQ button on main unit repeatedly to cycle through the following
equalization modes.
OPERATION
1. Press the POWER button to turn the unit ‘On’.
2. Select the Tuner function by pressing the TUNER button.
3. Select the desired band (AM or FM) with the BAND button.
4. Tune to the desired radio station by pressing the TUNE UP or TUNE DOWN
buttons on the unit or on the remote control.
5. If you hold the TUNE UP or TUNE DOWN button for more than half a second
the Tuner will begin to automatically scan until a strong signal is found.
6. To turn off the radio, press the POWER button to switch the unit into standby
mode. The STANDBY/MUTE indicator lights ‘RED’
STORING PRESET STATIONS
1. Tune either automatically or manually (as described in steps 4 or 5 above) to the
station to be stored.
2. Press the MEMORY/PROGRAM button
once. “MEMORY” will flash in the display
for 5 seconds. During this time you must
select the desired memory location by
pressing the MEM. UP/REPEAT button.
3. Press the MEMORY/PROGRAM Button
again to store the station at that location.
4. The unit can store up to 20 FM stations, 20 AM stations.
MHz
FM
POP
MEMORY CH STEREO
MHz
FM
POP
CH STEREO
ES8_ib.p65 8/10/01, AM 11:00 7