Emerson Radio ES8 - Manual (Page 3)

2
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
IMPORTANT NOTES
• Operate controls and switches as
described in the manual.
• Before turning on the power,
make certain that the connecting
cords and power cord are
properly installed.
• Store your CDs in a cool area to
avoid damage from heat.
• When moving the set, be sure to
first disconnect the power cord
and remove cords connected to
other equipment.
• Avoid installing this unit in places
exposed to direct sunlight or
close to heat radiating appliances
such as electric heaters, on top
of other stereo equipment that
radiates heat, places lacking
ventilation or dusty areas, places
subject to constant vibration and/
or humid or moist areas.
• Do not attempt to clean this unit
with chemical solvents as this
might damage the finish. Use a
clean dry cloth.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
ES8_ib.p65 8/10/01, AM 11:00 2