EDCO 2GC-NG-11H - Manual (Page 5)

E-2ECGCNG-I-0513
Printed in USA
©2013
Page 5
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com • Email: [email protected]
NOTE: THE ABOVE ILLUSTRATIONS ARE VIEWING THE MACHINE FROM THE
FRONT BOTTOM. NOTE THE DIRECTION OF ROTATION AND MULTI-DISC
STYLE. IF DISCS ARE REPLACED AND INSERTS FALL OUT WHEN BEING USED
THE DISCS HAVE BEEN INSTALLED INCORRECTLY.
Getting started with your new grinder
1. Loading tools -
Lean the machine back on the handle to expose the work area and load the proper tools for your job. Electric
machines should be unplugged, gas machines should have the spark plug wire removed.
Once all tools are in the proper position return the machine to upright. Remember if you are using tools with
PCD’s on Stripserts they have a leading edge and must be loaded as such. Also, remember both of the discs
turn in direction of arrows.