EDCO 2GC-NG-11H - Manual (Page 13)

E-2ECGCNG-I-0513
Printed in USA
©2013
Page 13
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com • Email: [email protected]
Dyma-Serts™ (Patented)
DYMA-SERTS™ are diamond segments welded to snap-
in plates for faster, controlled, dry grinding, and are ideal
for removing trowel marks, rough finish, rain spots, large
volume projects, paints, thin mastics, epoxy and urethane
coatings, or polymer enhanced surfaces. DYMA-SERTS™
can be used wet or dry and will outperform stones by
grinding many times faster, removing tough materials, and
lasting many times longer - up to 30,000 sq. ft. (2,800 sq.
meters) life (at 1/32”) dependent on depth of removal, coat-
ings, speed of operation, matrix, etc. Extra weight can be
added to the grinder to increase production. Choose the
DYMA-SERT™ to fit your job.
STRIP-Serts™
Are carbide-tipped blocks designed
to clean floors without grinding into the concrete. The multi-
sided, replaceable tungsten carbides have four edges that
can be rotated for maximum use. The carbide Strip-Serts™
will clean your surface without any damage.
DOUBLE DIAMOND DOTS
General Purpose
Grind - Removes General Purpose Epoxy, Matsics, Thin-
sets, Water-proofing Coatings and more. Use with the 7”
and 10” Quick-Change Multi-Accessory Discs.
PCD ACCESSORY
Extremely aggressive remov-
al. Digs through Industrial Strength Coverings, Water Proof-
ing Membrane, Thick Epoxies and Much more. Leaves a
textured concrete surface.
This is a Double Diamond Dots.
This is a PCD.
FOR USE WITH QUICK-CHANGE MULTI-ACCESSORY DISC
Spring clip
This is a DYMA-SERT, rotate the DYMA-SERT
only, not the case.
Accessory
case
This is a STRIP-SERT, rotate this blade to
expose a new cutting surface. There are four
(4) cutting surfaces on each blade.
Use a hex wrench to remove hex screw to allow
rotation of blade.