Ecler WPTOUCH - Manual (Page 8)

8
4.2. WPTOUCH Edition and Configuration Modes
In addition to the modes and status described in the previous
paragraph, to which a regular WPTOUCH user could access, there are two
device setting modes allowing to adjust a set of operating parameters.
These modes are "hidden" to a generic panel user: an advanced user, the
system installer or programmer must type a key sequence to access them,
and such a sequence is unlikely to happen accidentally. These modes are
named EDITION Mode and CONFIGURATION Mode.
4.2.1. EDITION Mode
This mode lets you change the text displayed on the LCD
screen for selecting an active source in analogue mode. From the digital
mode, the EDITION Mode is not accessible, since selection and device
names displayed on WPTOUCH screen are allocated from the MIMO88
and EclerNet Manager software.
Default names are "SOURCE n", where n is an integer between
1 and 17.
The sequence to follow is:
1.
From USER mode, press KEY 2 and, without releasing,
press KEY 1. Keep both keys pressed for 3 seconds.
2. On the screen, line 1 displays "EDIT SOURCE NAME"
and line 2 displays the name of the active selection.
3. Releasing KEY 1 then KEY 2 gives access to the editing
of the current selection’s name. On the screen, line 1
displays the message "USE <> and ROTOR". Line 2
displays the name of the currently active selection, left
justified and with a cursor blinking under the first
character.
4. In this status, the wheel has two operating modes:
•
as left/right navigation keys (clicking on the
positions corresponding at 9 and 3 in the face of a
clock), to move the cursor to the previous or next
character.
•
usual rotating mode, to change the character on the
cursor position.