DLE 170 User Manual
Page 6
6
3. Connect the ignition kill switch lead to the red connector from
the ignition control module using the lead from the kill switch or
with the included three pin connector with pig tail. Use the included
three pin securing clip to secure the connection.
4. Connect the ignition module battery to the kill switch. Any 4.8-
6.0V, 1000mAh and above capacity battery will work well for this.
Use heat shrink tubing to secure this connection.
5. Install the silicone ignition wire cover over the ignition wires to
the spark plugs.
6. Install the spark plugs into the engine cylinders (7-8lbs Torque).