Digilent MX7cK User Manual
Page 24
Cerebot MX7cK Reference Manual
www.digilentinc.com
page 24 of 36
Copyright Digilent, Inc. All rights reserved. Other product and company names mentioned may be trademarks of their respective owners.
JP8
CAN #1 5V0 Enable
This jumper is used to enable/disable providing 5V to the CAN #1 connector. Insert the
shorting block to connect the board 5V0 supply to pins 9 & 10 of CAN #1 connector. Remove
the shorting block to disconnect the 5V0 supply.
JP9
Do Not Use
JP10
USB host power select
This jumper is used to select which host connector is powered when host power is enabled.
Place the shorting block in the
“MICRO” position to supply power to the USB micro-AB OTG
Connector, J19. Place the shorting block in the “A” position to supply power to the USB type
A Host Connector, J20.
JP11
USB Serial converter reset disconnect
This is used to connect/disconnect the USB serial converter reset circuit from the PIC32
MCLR pin. The shorting block must be in place on this jumper when using the chipKIT
MPIDE development tools. Remove the shorting block if the USB serial converter is
interfering with proper operation of the licensed debugger circuit.
JP17
Do Not Use