Supported target devices – Digilent 210-299P-KIT User Manual

Page 4

JTAG-HS3 Reference Manual

Other product and company names mentioned may be trademarks of their respective owners.

Page 4 of 6

Supported Target Devices

The JTAG-HS3 is capable of targeting the following Xilinx devices:



Xilinx FPGAs



Xilinx Zynq-7000



Xilinx CoolRunner™/CoolRunner-II CPLDs



Xilinx Platform Flash ISP configuration PROMs



Select third-party SPI PROMs



Select third-party BPI PROMs

The following devices cannot be targeted by the JTAG-HS3:



Xilinx 9500/9500XL CPLDs



Xilinx 1700 and 18V00 ISP configuration PROMs



Xilinx FPGA eFUSE programming

Remote device configuration is not supported for the JTAG-HS3 when used with Xilinx’s iMPACT software.

Note: Please see the "Introduction to Indirect Programming – SPI or BPI Flash Memory" help topic in iMPACT for a
list of supported FPGA/PROM combinations.

Note: Please see the “Configuration Memory Support” section of Xilinx UG908 for a list of the FPGA/PROM
combinations that Vivado supports.

Design Notes

The JTAG-HS3 uses high speed three-state buffers to drive the TMS, TDI, and TCK signals. These buffers are capable
of sourcing or sinking a maximum of 50 mA of current. The HS3 has 100 ohm resistors between the output of the
buffers and the I/O pins to ensure the cable does not exceed the maximum limit. To further limit short circuit,
additional current resistance may be placed in series with the I/O pins of the HS3 and the target board. However,
Digilent recommends limiting the amount of additional resistance to 100 ohms or less as higher resistance may
result in degraded operation.