Digilent 6002-410-007 - Manual

1300 Henley Court
Pullman, WA 99163
509.334.6306
www.digilentinc.com
Digilent myProto
™ Reference Manual
Revised November 14, 2014
DOC#: 6002-502-007 Copyright Digilent, Inc. All rights reserved.
Other product and company names mentioned may be trademarks of their respective owners.
Page 1 of 2
Overview
The Digilent myProto accessory board for NI myDAQ attaches directly to the myDAQ and brings all myDAQ signals
to breadboard connections where they can be easily accessed using simple jumper wires. The myProto also
includes several additional useful I/O devices. Signal names on the myProto breadboards indicate which myDAQ
signals and onboard devices are attached to which breadboard pins. All Ground connections on the myProto
breadboards are connected into a single Ground node on the myProto device.
The Digilent myProto board.

Solderless Breadboard

All myDAQ signals accessible from breadboards

3 onboard user LEDs

1 10K Potentiometer

2 Audio Jacks

External power connector for breadboard
circuits

Switches on all power supplies
Pin Function Pin Function Pin Function
AJ1 S1 Audio Jack 1 Sleeve AJ2 T2 Audio Jack 2 Tip AO 1 Analog Out Pin 1
AJ1 T1 Audio Jack 1 Tip AJ2 R2 Audio Jack 2 Ring AI0 GND Analog In Ground
AJ1 R1 Audio Jack 1 Ring PWR 5V myDAQ +5V supply AI0 0+ Analog In Ch0+
PWR +15V myDAQ +15V supply PWR GND Ground AI0 0- Analog In Ch0-
PWR -15V myDAQ -15V supply PWR Vext From Vext Jack AI1 GND Analog In Ground
PWR GND Ground AO GND Ground AI1 1+ Analog In Ch1+
AJ2 S2 Audio Jack 2 Sleeve AO 0 Analog Out Pin 0 AI1 1- Analog In Ch1-
DIG GND Digital GND DIG DIO4 Digital I/O 4 LED Y Yellow LED
DIG DIO0 Digital I/O 0 DIG DIO5 Digital I/O 5 LED R Red LED
DIG DIO1 Digital I/O 1 DIG DIO6 Digital I/O 6 Pot CCW Pot Counter-CW
DIG DIO2 Digital I/O 2 DIG DIO7 Digital I/O 7 Pot Wiper Pot Wiper
DIG DIO3 Digital I/O 3 LED G Green LED Pot CW Pot CW
Table 1. Digilent myProto signals.