D.A.S. Audio Aero - Manual (Page 9)

Low frequency mono-amplified system.
Nominal amplifier power (RMS) 1000W.
Amplifier panel description:
mplifier limiter indicator lights.
When lit, the level of the signal source should be
reduced.
Signal presence indicator at the
amplifiers' inputs.
Indicator light for each amplifier
channel.
With PowerCon NAC 3 FCA
connector. Only when the connector is inserted and
rotated (clicked) into place will the AC turn on. The
connector can be used as a switch, rotating the
connector to or from the locked position will turn the
unit on or off, respectively. Mute the signal feeding the
before turning the unit on or off.
Balanced signal XLR. Pin
assignments as follows :
Used for paralleling several
units, which will share the same input. Could also be
used to provide signal for an outboard power amplifier.
H) : Used to control the
subwoofer level. To prevent accidental mis-setting, a
flat-blade screwdriver is needed to rotate the control,
which is recessed and detented. Depending on the
sensitivity, placement and configuration of your mid-
high system, you may need to adjust this control for
balanced frequency response.
INPUT
SUB LEVEL
NOTE: The amplifiers on the AERO-218A
and AERO-182A systems do not inlclude a filtered
satellite output for AERO-38A systems.
A) : A
B) :
C) :
D) .
) :
F) :
1=GND (ground)
2=(+) Non inverted input
3=(-) Inverted input
G) :
LIMIT
SIGNAL
ON
FUSE
E AC INPUT
INPUT
LOOP THRU
3.2 AERO-182A
The required voltage for all models is:
115V, 50Hz/60Hz - 230V, 50Hz/60Hz
Maximum voltage (divide by 2 for115V):
264V
Shutdown voltage (divide by 2 for 115V):
Aero-38A: 156V
Aero-182A / Aero-218A: 160V
3.5 CURRENT CONSUMPTION
F
D
H
G
A
C
B
E
Amplifier panel on AERO-218A and AERO-182A
systems.
3.3 AERO-218A
The Aero-218A is a low frequency mono-
amplified system.
Nominal amplifier power (RMS) 2 x 1000W.
3.4 AC POWER REQUIREMENTS
AERO-182A / AERO-218A *
Maximum Power
AERO-38A
Maximum Power 8A
Sine 85Hz
2.5A
Pink noise
1/3 Power
3.2A
1/8 Power
1.6A
Idle
0.25A 0.25A
Data obtained at 230V, multiply per 2 for 115V.
*For 2000W versions multiply per 2.
Maximum power: Measured in conditions of severe
clipping.
1/3 Power
1/8 Power
Idle
Aero-38
Manual del usuario/ User´s manual 49
7A 2.5A
Sine 50Hz Pink noise
3.0A
----
----
1.1A
0.1A
0.1A
----
----