D.A.S. Audio Aero - Manual (Page 22)

Once the two PL-48S_2 have been attached
to the boxes (3) using one safety pin per piece, the PL-
48S_1 pieces can be attached. Remove the safety
pins (4)and insert the PL-48S_1 pieces into the rigging
hardware (5) securing them (6) by using two pins per
piece.
Once the PL-48S_1 and PL-48S_2 have
been secured to the lower box, this should be lowered
so that the PL-48S_1 piece can be secured to the PL-
48S platform (7) using the safety pins.
62
Aero-38
Manual del usuario/ User´s manual
Release the PL-48S_2 piece by removing
the safety pins (1). Next, swing the pieces and
introduce them (2) into the rear rigging hardware of
the lowest box, securing them with the safety pin (3).
1
2
6
4
5
3
7
G2A48
Quick release pin
must be inserted
in the position 0º
Turn a
few degrees to allow fixing
PL-48S_2 to the rigging system
the piece G2A48
PL-48S_2
4
1
8
8
9
2
3
6
8
8
9
9
9
5
7
8
With the number 5, 6,7 and 8 boxes resting
on each other, the safety pins that define the splay
angle can be removed (8) and the PL-48S_2 guides
can return to their stored position (9). It is mandatory
to remove the safety pins between boxes 3-4, but
between 4-5, and 5-6, they can be left in place with
the angle prepared for the next event.