D.A.S. Audio Aero - Manual (Page 34)

5. SUBWOOFER UNITS
Self powered systems:
AERO-218A
AERO 182A
High Pass Filter in an AERO-38A system is set at 60Hz. is the D A S recommended
subwoofer unit to be used along AERO-38A when subwoofers have to be ground stacked. When subwoofers
be flown,
is the D A S recommended subwoofer.
Note: Due to the frequency overlap in the region between 60Hz and 80Hz, an external processor
(DSP-1Sub) will always be necessary in order to add the necessary delay so the phases of the AERO-38A and the
subwoofers match.
All self powered units incorporate the necessary
signal treatment in the amplifier, including cut off frequencies, limiters settings, etc.!!
. . .
are to
- . . .
LINK
2 x [750-1200]W@4ohm
2 x [750-1200]W@4ohm
2 x [750-1200]W@4ohm
2 x 750W@4ohm
±4HF
±3MF
±2LF2
±1LF1
±4HF
±3MF
±2LF2
±1LF1
80Hz
±1LF1
CH-A CH-B
RECOMMENDED AMPLIFIERS
±1LF1
DSP-3VS
LINE IN
DSP-1Sub
2 x 1400W@4ohm
LINK
Externally amplified systems:
AERO-218Sub
AERO 182
subs' Low Pass Filter be set at 80Hz
An AERO-38 unit can reproduce frequencies as low as 60Hz. is the D A S recommended
subwoofer unit to be used along AERO-38 when subwoofers have to be ground stacked. When subwoofers be
flown, is the D A S recommended subwoofer.
It is recommended that the , so that the band ranging from 60Hz to
80Hz is reproduced by both the AERO-38 and the subwoofer. The phase of the subs should match that of the Lows
around the 60Hz to 80Hz region.
. . .
are to
- . . .
Manual del usuario/ User´s manual 74
Aero-38