D.A.S. Audio LX-218RA - Manual (Page 14)

Troubleshooting
8
EN
PROBLEM
No sound from the unit. The
SIGNAL presence LED indicator(s)
do(es) not light up.
Full power cannot be obtained. The
overload
LED indicator(s) never
light(s) up.
Sound is distorted. The overload
LED indicator(s) is/are not on, or
only light up occasionally.
Sound is distorted and very loud.
One
or more overload LED
indicators light up.
Hum or buzz when a mixer is
connected to the unit.
Hum or buzz when using lighting
controls in the same building.
The power on LED indicator(s)
do(es) not light up when the power
connector is rotated and locked at
the ON (LOCK) position.
No sound from the unit. The
Protection LED indicator is on.
CAUSE
1 – The signal source is sending no
signal.
2 – Defective cable.
The signal source does not have a
hot enough output.
The mixer or signal source is
distorting.
The system is overloaded and has
reached maximum power.
1.– The console probably has un-
balanced outputs. You may be using
an
incorrect un-balanced to
balanced cable.
2.– The mixer and the powered
speaker are not plugged into the
same mains outlet.
3.– The audio signal cable is too
long or too close to an AC cable
1.– The audio signal cable is too
long or too close to the lighting
cable.
2.– On a sound system with three-
phase AC, the lighting equipment
and the UNIT are connected to the
same phase.
1.– Bad or loose AC connection to
the UNIT or the mains outlet.
2 – Faulty AC cable.
3 – Blown Fuse.
1.- Mains voltage very low or very
high.
2.- Overheating.
3.- Overload or short-circuit.
4.- DC at amplifier’s output.
SOLUTION
1 – Check that the mixer or sound
source is sending signal to the UNIT.
2 – Check that the cable from the
sound
source to the UNIT is
connected correctly. Replace the
cable if defective.
If using a mixer, use the balanced
output
if available. Use a
professional mixer with a hotter
output.
Turn mixer channel gains down.
Check that none of your signal
sources are distorting.
Turn down the mixer's output.
1.– Read the appendix of this
manual to make a correct un-
balanced to balanced cable.
2.– Connect the mixer and the unit
to the same mains outlet.
3.– Use a cable that is as short as
possible and/or move the audio
signal
cable away from mains
cables.
1.– Move the audio signal cable
away from lighting cables. Try to find
out at what point the noise is leaking
into the system.
2.– Connect the sound system to a
different phase than the lights. You
may need the help of an electrician.
1.– Check you connections.
2.– Check the cables, connectors
and AC power with a suitable mains
tester.
3.- Take the unit to a service centre
for replace the blown fuse.
1.- Check mains voltage with a
suitable mains tester.
2.- Check input signal because the
level or the EQ are very high.
3.- Take the unit to a service centre.
4.- Take the unit to a service centre.
Manual del Usuario / aero 38A & LX-218RA / User’s Manual