beautypg.com

Comtrol RocketPort USB Serial or Modem Hub Driver Installation with Windows 98 User Manual

Page 3

background image

Installing a Single RocketPort USB Serial or Modem Hub

3

Installing a Single RocketPort USB Serial or Modem Hub

Use the following procedure to initially install the RocketPort USB Hub hardware and software. If you have
installed a previous version of the device driver, you must remove it before installing an updated driver. See
the

Removing the Software

discussion before reinstalling a driver.

Note: If you downloaded the driver from the

ftp

/

Web

sites, make sure that you

extract

the driver before

installing the software.

1.

Plug the B end of the cable into the RocketPort USB Hub back panel labeled USB-B.

Note: If your installation requires power, connect a power adapter to the RocketPort USB Serial or

Modem Hub and a power source before connecting the unit. If you do not connect the power at this
time, the installation will fail.

2.

Plug the A end of the cable into your USB port on your computer or USB Hub.

Note: The Power light (amber) on the front of the unit indicates that there is power coming into the unit.

3.

If this is the first Comtrol USB device that you are installing on this computer, click the Next button when
the following screen appears. This procedure installs the platform for installing USB Devices.

Note: If the first screen that appears for the installation is NOT searching for the USB Composite Device

driver, go to

Step 10

.