Comtrol RocketPort 550 uPCI Windows NT - Manual (Page 4)

4
4. Installing the WinNT4 Device Driver
This SETUP program allows you to INSTALL or DE-INSTALL a Windows NT4
device driver for the RocketPort 550 and/or RocketPort 550 Universal controllers.
1. From the start menu select Run
2. Enter c:\Comtrol\Installations\Rp550nt4\Setup
then Click OK
Note
If you extracted the driver files to a different folder then enter the path to that folder
Alternatively, click the Run dialog’s browse button and find the RocketPort 550
/RocketPort 550 Universal Windows NT 4 setup file using the browse dialog.
3. The welcome dialog will appear.
Click Next
4. The Install/Uninstall dialog will be displayed.
Select INSTALL
Click Next
5. The license agreement dialog box will appear
Click Yes to accept the license and continue
Or
Click No to decline and abort the installation
6. The select starting COM port dialog box will appear.
Enter the starting COM port NUMBER or use the drop down list
(click the ‘down’ arrow) to select a starting com port number.
Note: The starting COM port number specifies the first RocketPort 550/RocketPort 550
Universal COM port and the beginning of the range of COM ports allocated to the installed
RocketPort 550/RocketPort 550 Universal These COM ports must be free for use by the
Controller before installation.
Wait On Tx should normally be left un-checked unless the application requires
the option. See the following note:-