Comtrol RocketPort 550 uPCI Linux - Manual (Page 4)

4
2. Installing the RocketPort 550 Linux Device Driver
software
NOTE
The Comtrol Linux driver release 2.02 was developed using the RED HAT 8.0
distribution with Kernel revision 2.4.18-14.
The driver source is provided should developers wish or need to modify the driver for
use with alternative Linux distributions and/or Kernels. For use with other 2.4.x kernels,
a simple re-compilation (on the target system) is all that may be necessary and a
‘Makefile’ is provided to automate this process. Before (re)compilation, the kernel
source
must be installed.
For test purposes, the driver source was (re)compiled under Red Hat 7.3 kernel 2.4.18-3.
The driver module was installed and functioned correctly.
This driver source will not (re)compile under the obsolete 2.2.x kernels.
The installation media (i.e. what you are installing from) may be a CD ROM, 1.44Mb floppy
diskette or a CD-ROM. Alternatively, you may have downloaded the driver from
http://www.comtrol.com
There may be minor differences in the installation procedure depending on the
installation media.
If you have downloaded the driver from
http://www.comtrol.com , then it is suggested
that you copy the ‘tar’ file to an MS-DOS formatted floppy diskette and follow the
floppy disk based installation procedure
Following download, you may need to unzip the downloaded file in order to obtain the tar file. The tar
file name will be of the format relXXX.tar where XXX is the release number. E.g. XXX = 202 =
release 2.02
The following assumes that you have booted Linux and logged in as root.
Step 1
Extract the files from the installation media. First insert the floppy diskette or
CD into the relevant drive and mount the media so that the file can be accessed.
DISKETTE
[root@localhost root]# mount -t msdos /dev/fd0 /mnt/floppy
CD ROM
[root@localhost root]# mount /dev/cdrom /mnt/cdrom