Comtrol Modbus Server User Manual

Page 31

DeviceMaster Modbus Server User Guide: 2000535 Rev. C

Embedded Web Pages - 31

Edit Network Configuration Page

You can use the Edit Network Configuration page to change the DeviceMaster
network configuration after using PortVision DX for initial network configuration.

Use the following procedure to change the network configuration.

Select the IP configuration type (Use DHCP or Use Static configuration below:).

If you select Use Static configuration below, enter a valid IP address, subnet
mask, and IP gateway for your network. The network information is
programmed into the DeviceMaster after applying the changes and rebooting
the device. If necessary, see your network administrator for a valid IP address.

Note: The DeviceMaster family default IP address is 192.168.250.250, default

subnet mask is 255.255.0.0, and the default IP gateway is
192.168.250.1.

Select Save or Undo Changes to close the page.

If you selected Save, select Reboot to program the network information into the
DeviceMaster or Continue if you want to reboot later.

Note: Changed network settings will not take affect until the DeviceMaster is

rebooted.