Comtrol RocketPort Plus 422 Universal PCI - Manual (Page 8)

8 - Card and Interface Installation RocketPort uPCI Plus 422 User Guide: 2000370 Rev. B
Card and Interface Installation
9. Attach the DB78 end of the quadcable or octacable to the card.
Make sure that the connectors are properly
aligned and forcefully push the connector of
the Octacable with a rocking motion into the
card connector. Make sure that the connector
is seated tightly before tightening the
retaining screws on the connector.
10. Tighten the retaining screws on the connector.
11. Power on the host system.
12. Click Cancel if a Found New Hardware message
appears on a Windows operating system.
Execute the device driver file to start the driver installation.
For other operating system device drivers, see Locating the Latest Drivers and
Documentation on Page 6.
13. After installing the driver, you should verify that the ports are functioning
properly and then connect your serial devices.
You can use the Troubleshooting section on Page 13 for port testing procedures
for your operating system.
Refer to Connecting RS-422 Serial Devices on Page 9 for information about
connecting serial devices.
Caution
Octacable
DB9