beautypg.com

Programming the ip address – Comtrol ES9528-XT Quick Start User Manual

Page 6

background image

5

PROGRAMMING THE IP ADDRESS

Configure the IP address using one of the following methods:

PortVision DX (available on the RocketLinx CD shipped with the product

Web browser

Telnet

Command line interface (CLI) using the RS-232 console cable

The easiest way to configure a static IP address for your network in the

ES9528 is to use a Windows host and PortVision DX (see below). For

information about using other configuration methods, refer to the RocketLinx

ES9528/ES9528-XT User Guide.
Note: Optionally, you can use NetVision if you are accustomed to using

NetVision. PortVision DX replaces NetVision. NetVision is not documented in

the RocketLinx ES9528/ES9528-XT User Guide.
The following procedure uses PortVision DX to program network settings.
1. Install PortVision DX on a host system with a Windows operating system.

If you need assistance installing PortVision DX, see the RocketLinx

ES9528/ES9508-XT User Guide.

2. Start PortVision DX. PortVision DX can be started from Start --> All

Programs --> Comtrol --> PortVision DX.

3. Click the Scan button.

4. Select the Comtrol product families that you want to locate and click the

Scan button.

5. Right-click the ES9528 in the Device List pane (lower) that you want to

configure and click Properties.

6. Enter a user-friendly Device Name.

7. Optionally, enter the ES9528 serial number, which displays a friendly

device name in the Device List pane on the main page.

8. Select DHCP IP or Static IP for the IP Mode.

If you select DHCP IP, go to Step 9.

If you select Static IP, enter an IP address, Subnet Mask, and

Default Gateway value for your network.

This manual is related to the following products: