COMP Cams 4943 Camshaft Degree Kit for Ford 5.0L 4V User Manual

Instructions, Initial setup

COMP Cams

3406 Democrat Rd.

Memphis, TN 38118

Phone: (901) 795-2400 Fax: (901) 366-1807

www.compcams.com

Part #COMP4-170

Revised 6/28/13

#4943 Parts List

(1) Crankshaft Socket
(1) 9" Degree Wheel
(1) Cam Checking Fixture
(1) Metric Adapter
(1) 0-1" Travel Dial Indicator
(1) 5" Dial Indicator Extension
(1) Wire Degree Wheel Pointer
(2) Checking Springs
(1) 14 MM Piston Stop

Camshaft Degree Kit for Ford 5.0L 4V Coyote #4943

Thank you for choosing COMP Cams

products; we are proud to be your manufacturer of choice. Please read

this instruction sheet carefully before beginning installation, and also take a moment to review the included
limited warranty information.

Initial Setup

1) Prepare a clean work area and assemble the tools needed for the camshaft degreeing. It is suggested to

use an automotive manual to help determine which items must be removed from the engine in order to
expose the timing chains, camshaft phasers and camshafts. A good, complete automotive manual will
save time and frustration during the installation.

2) Remove the engine valve covers.

3) Assemble the stand to hold the

dial indicator, start by screwing
the adapter piece to the bottom of
the dial indicator stand.

Install the assembled stand with
the metric adapter and dial
indicator attached so that you can
begin by degreeing the intake cam
on cylinder 1 Tighten the
assembly into the threads for
mounting the valve cover.

INSTRUCTIONS