Compaq V300 - Manual (Page 154)

Power Cord Set Requirements B-1
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Writer: David Calvert Saved by: The Integrity Group Saved date: 10/25/00 5:48 PM
Pages: 2 Words: 403 Template: c:\msoffice\templates\ref\ref.dot
Part Number: 128679-006 File name: Appb
appendix B
P
OWER
C
ORD
S
ET
R
EQUIREMENTS
3-Conductor Power Cord Set
The wide range input feature of the Armada E500 and Armada V300
Series of Personal Computers permits them to operate from any line
voltage from 100 to 120 or 220 to 240 volts AC.
The power cord sets received with the computers meet the requirements
for use in the country where the equipment is purchased.
For more information on power cord set requirements, contact a Compaq
authorized reseller or service provider.
General Requirements
The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 5.00 feet (1.5 m)
and a maximum of 6.50 feet (2.0 m).
2. All power cord sets must be approved by an acceptable accredited
agency responsible for evaluation in the country where the power
cord set will be used.
3. The power cord set must have a minimum current capacity of 10A
and a nominal voltage rating of 125 or 250 volts AC, as required by
each country’s power system.
4. The appliance coupler must meet the mechanical configuration of an
EN 60 320/IEC 320 Standard Sheet C13 connector, for mating with
appliance inlet on the back of the computer.