Toshiba KV-5124A - Manual (Page 5)

Head cleaner and power faHs display
• A head cleaning unit is provided to prevent the head from being clogged- When the tape end has been detected during
recording, when the video cassette has been ejected and once every 2 hours during recording pause, the head cleaner will
automatically operate for about 1 second.
• When the tape end is detected, an electric buzzer sounds and the counter display blinks. To stop the blinking, press any button.
• When power fails, the 'TWTAIL" mark blinks on the display. Press any button to erase the mark.
(Í7) CLOCK SET button
This button is used to program the time. {Refer to detailed
programming instructions,)
(J|) PGM button
This button is used program the timer, (Refer to detailed
programming instructions.)
@ SET (-)/( + ! button
These buttons are used to program the time or timer. {Refer
to detailed programming instructions,)
MEMORY button
This button is used to program the time or timer. (Refer
to detailed programming instructions.)
@ CFM/SKIP button
Pressing the
CFM
(confirm) button while in the stop mode
causes the contents of the timer memory to be shown on
the on-screen display. Press this button In timer setting
mode. "SKIP" is displayed where programmed times were,
and the program will be skipped for recording. Press it again
to display the programmed times.
COUNT, button
Pressing the
COUf^T.
button displays the tape counter or
the alarm counter on the MODE DISPLAY,
COUNT. MEMORY button
Pressing
the COU^T. MEMORY button causes the
"CiDUNT. M” (counter memory) to appear on the MODE
DISPLAY. If the tape is fast-forwarded or rewound while
in this mode the tape will stop automatically at a count
of "0000", Pressing this button twice causes the "ALARM
M" (alarm memory) to be displayed. If the tape is fast-
forwarded or rewound while in this mode the tape will stop
automatically at the beginning of an alarm and enter the
STILL, PLAYBACK mode. Pressing the buttor> three times
carreéis this function.
RESET button
• Pressing the RESET button while in the tape counter
mode resets the tape counter to "0000", Pressing the
RESET button while in the alarm counter mode resets
the alarm counter to "A-00".
• Press this button to release the alarm recall that has been
recorded, (max 5 programs)
ALARM RECALL button
Pressing the ALARM RECALL button while in the stop
mode will begin an on-screen review of all alarms which
have been recorded. Each alarm will be displayed along
with the time and date associated with that alarm of 5 se­
conds. During this sequential display period the
SET ( + )
and SET {- ) buttons may be used to advance or recall the
alarms displays.
LOCATION SELECT buttons
Pressing these buttons will position the on-screen display.
The display will move in the direction of the arrows marked
on the buttons. When the display reaches the border of
the picture it will "wrap around'' to the other side.
TIME MODE buttons
These buttons are used to select recording speed. Press­
ing the button marked with the up or down arrow will
increase or decrease the record speed which will be shown
on the display panel.
ON SCREEN DISPLAY switch
This switch allows you to select how much information
appears in the on-screen display. In the "OFF" position
the entire display is off. In the "1ST" position only one
line containing time and alarm information will be dis­
played. tn the "2ND" position a second line containing date
information will be displayed.
CASSETTE COMPARTMENT
When a cassette is inserted into the cassette compartment,
the mechanism will automatically load the tape into this
VCR.